undefined
undefined
undefined
undefined
undefined
undefined
undefined
+
  • undefined
  • undefined
  • undefined
  • undefined
  • undefined
  • undefined
  • undefined

DST-660X-EX-ab-K7/K7 switch quantity output isolated safety barrier

Classification:

Switching quantity output

DST-660X-EX-a/b-K7/K7 is the isolation barrier of the switch output operation terminal, which controls the power supply of the safe area through the switch to drive the on-site safety equipment in the dangerous area. It allows the control switch to be directly connected to any end of the 24V power supply circuit. This product is suitable for driving such as solenoid valve, sound and light alarm and other safety equipment. According to GB/T 3836.1-2021 and GB/T 3836.4-2021, it has passed the inspection and obtained the ccc certificate. It is suitable for installation and use in safe areas and can be used together with intrapexy safety equipment in Zone 0, Zone 1 and Zone 2 of explosive gas hazardous places.

Keywords: Isolator

Product Consulting
Product Manual
Mall Purchase
  • Technical parameters
  • Structural outline drawing
  • Ordering Guide

  • Technical parameters

     

    Hazardous side
    output equivalent circuit See equivalent circuit diagram below
    Open circuit output voltage 24-26V
    Output characteristics 12V/35mA、12V/45mA、12V/60mA
    Safety side
      Supply power to hazardous area equipment when the input switch is closed or the transistor is on
    When the input switch is off or the transistor is not conductive, power is not supplied to the hazardous area equipment

    1

    General technical parameters 

     

    Power
    Power DC24V ±10%
    Power consumption Power consumption: ≤ 2.5W
    Other parameters
    Insulation strength
    (Between Inthenine Safety End/Non-Inthenine Safety End)    		 1500Vrms (1 min, no spark)

    Working temperature
    Relative humidity

    		 -10~50 ℃ (no condensation, no icing)
    25%～85%RH
    save temperature -10~60 ℃ (no condensation, no icing)
    Installation method 35mm DIN rail mounting
    Mounting dimensions 17.5*111.4*121.2mm (width * height * depth)
    Transmission accuracy (20 ℃) 0.2%FS ± 1 word
    Weight About 130 grams
    Electromagnetic compatibility Comply with GB/T18268 industrial equipment application requirements (IEC 61326-1)
    Applicable field equipment Two-wire, three-wire transmitter, DC current source

  • Structural outline drawing

    结构外形图

    General Structure Exterior

     

    通用结构外型图

  •  

    1

     

    For example:

    Input signal: RS485, output signal: RS485 (power distribution 9V), one in and one out. Type selection: DST-60811-EX-37-D1-V3;